Motorhome fit out, On the road problems

Big Bus Big Adventure Air Conditioner ???

Is The Air Conditioner Working

The condenser unit was fitted in the front bin on the drivers side and only had an out vent so if the bin door was closed, things didn’t work that well. This should have been one of the first things  that I should have fixed, but as we were not on the road much I didn’t think about it at all. Now after driving from S.A. to N.T. and now into QLD, it was defiantly time to fix it.

Only one vent that didn’t work to well.
Air-con that was fitted.

Time For Some Modifications

To start with we had to seal the air-con unit to the outside bin door, so off to the hardware store for some sheetmetal. Ended up getting some flashing which would mean I would not have to bend any 90 angles. So out with the tin snips and pop rivet gun to make some ducting.

Made up some ducting to get the air out.
Rubber seals in place so the hot air only go’s outside.

Time For Some Intake Vents

Now all we had to do was the intake vents,  I thought three would do for a start and thats all they had at the hardware. So back to the coach I went to start fitting the intake vents. First off was to mark out the holes for the vents then cut them out.

Marked and cut out ready for the new vents
New vents in place so no more over heating while driving down the road.

One Cool Motorhome.

Now that job is done It’s so much cooler inside when driving down the road. Also when we stay somewhere I don’t have to open up the air-con’s bin door again, now that all the hot air is blown outside.