Bedroom Ceiling…. Time To Prep

Over My Head….. Just.

The bedroom ceiling is the lowest overall in the back of the coach, so it just touches the top of my head. The old ceiling carpet had already been removed by Des, so all I had to do was grind the toilet ceiling panel off then scrap back the foam underlay that was glued to the ceiling.

Old Toilet ceiling, it had a 10mm step down made out of sheetmetal.
Toilet ceiling after removing the sheetmetal panel.

Time To Remove The Underlay

With scraper in hand it was time to start scraping back all the old underlay. This might sound like an easy job, but it had been glued up there very well. I thought it wouldn’t take to long, but I was wrong again as the bedroom ceiling end up taking around 8hrs just to get the foam off.

Stripping the foam off.
Last of the foam off the bedroom ceiling.

Now To Get Rid Of That Glue

With the contacted glue still all over the ceiling, the only way that I could think to do was to put a sanding disc on a grinder and go for it. Well… it worked, I had been covered in glue and dust. Thank goodness for a dust mask and safety glasses as once I was finished the job there was crap all over the place.

Now time to get covered in crap.
Almost there.
All the old glue has gone with most of it on me…

I’ll Just Keep On Going

Now that I’ve started on the ceiling, I’ll keep on going and finish it all off inside the coach. The next project will be the bathroom then onto the kitchen ceiling area, so once I have cleaned all that up it will be ready to glue and pop rivet some white Colorbond sheet metal that came with the coach from Des. The ceiling is a good job to do when the weather is wet and raining so while its nice and fine I will go finish removing the old air-con on the roof above the bedroom, they are the wholes in the ceiling you can see on the photo.

 

4 thoughts on “Bedroom Ceiling…. Time To Prep”

  1. That does not look like fun to me at all. I bet you will be glad when that job is finished.

Comments are closed.