Some finishing off bits on the outside

The fiberglass panels needed to be finish off by putting aluminium around them. So off to the shops again, I think I should have shares in Bunnings. I though this was going to be an easy job of just cutting the aluminium to length and gluing then pop rivet into place.

Prep time

To start with I had to remove the old pop rivets that held the old air-con fiberglass top in place. This was a job in itself as it was glued well in place, then clean out all the dust that had built up over 30 years.

Slow job cutting the old glue to lift the fiberglass out.

I’m glad I started this job early in the fixing as I found another place where water could get in that was hidden. This should be the last of them as there is no more places left to fix.

This back part took one day to free up, not happy.

I even had the reciprocal saw going to cut out the old glue and on this part, but the saw died with only 300mm to go. They knew how to glue things back then, too well. The only good news was there was more room under the coach now the saw was in the bin.

Aluminium flat bar time

Well now it’s out with the measuring tape and start cutting things to length, or just make it up as I go along. I made up a templet so they would all end up in a straight line, well that is the plan.

50 X 3mm aluminium flat going into place.

Working off one ladder is not the best idea, but that is all we have. So now the sequence was marking out the holes for the pop rivets, then pre-drill 3mm holes. I had to hold the aluminium in place with tape, and drill into the coach, then drill them out to 5mm C/S pop rivets to fit. Next was to take the aluminium down, counter sink the holes for the pop rivets, put Sikaflex on the back, to fit it into place. I had to put two pop rivet in at arm’s length, climb the ladder holding the aluminium by the pop rivets. This was difficult! Even allocating the pop rivets into their holes to fit the rest of the pop rivets in place was a feat! I had to buy a pneumatic pop rivet gun which made my life much easier 🙂 happy days.